
Turn a song into baritone sax MIDI you can edit. Upload MP3, WAV, M4A or FLAC, leave baritone sax selected, check the low line on the piano roll, then drop the .mid into your DAW.
Play the source beside the piano roll. Low sax phrases are easier to trust when you hear the same beat before export.
This landing opens Audio to MIDI with baritone sax already chosen. MIDI stays on the low sax line instead of the whole horn section.
Download the unquantized .mid for a bari patch. Set octaves and pocket so the low horn anchors the stack.
Isolate baritone sax with Stem Splitter first if the mix is dense, then upload that stem here.
Tenor sax and electric/upright bass have their own MIDI landings.
From the bari take you have to a .mid you can rewrite.
MP3, WAV, M4A or FLAC — bari solo or mix where the low sax is clear. Or pick from My Music.
This page already chooses baritone sax. Add another part only if it should share the MIDI.
Scrub phrases and octave placement against the recording before export.
Take the transcription MIDI into Ableton, Logic, or FL Studio.
When the roll looks right, take the .mid into your DAW. Printable bari staff is the sheet sibling's job.
Preferred DAW import — History surfaces the unquantized transcription MIDI first. Drop it into Ableton, Logic, FL Studio, or similar.
Drop the .mid on bari, then set octaves and pocket so the low horn anchors the stack.

If the bari is buried under the rhythm section, isolate it first — then convert that stem.
Solo bari or a mix where the low sax sits up front beats a muddy full band.
Use Stem Splitter for baritone sax, upload the stem here, or leave Auto on if the line is already obvious.
Set bari octaves and pocket so the low horn anchors the stack.
“Bari hook became MIDI I could fatten under the chorus without retracking.”
“Hard mask kept tenor out of the bari clip. Low end stayed honest.”
“Dropped the MIDI into Logic, then locked the octaves. Solid bari foundation for the stack.”
Keep going — these tools pair well with what you just read.

Upload the take, keep baritone sax selected, and download a .mid for your DAW.