
Turn a song into brass section MIDI you can edit. Upload MP3, WAV, M4A or FLAC, leave brass section selected, check the stack on the piano roll, then drop the .mid into your DAW.
Play the source beside the piano roll. Stacked hits and pads are easier to trust when you hear the same beat before export.
This landing opens Audio to MIDI with brass section already chosen. MIDI targets the choir-style stack instead of a single solo trumpet.
Download the unquantized .mid and break voicings across trumpet, horn, and trombone tracks — a section MIDI you can explode and revoice in your DAW.
Isolate brass with Stem Splitter first if vocals dominate, then upload that stem here.
For a single trumpet, trombone, horn, or tuba line, use that instrument's MIDI landing instead.
From the brass take you have to a .mid sketch you can split.
MP3, WAV, M4A or FLAC — horn section hit, pop brass stack, or a mix where brass is clear. Or pick from My Music.
This page already chooses brass section. Add another part only if it should share the MIDI.
Scrub hits and pads against the recording before export.
Take the transcription MIDI into Ableton, Logic, or FL Studio. Revoice across instruments there.
When the roll looks right, take the .mid into your DAW. Printable parts are the sheet sibling's job.
Preferred DAW import — History surfaces the unquantized transcription MIDI first. Drop it into Ableton, Logic, FL Studio, or similar.
Import the section .mid, then revoice stabs and split parts across your brass choir.

If the brass is buried under vocals, isolate it first — then convert that stem.
A clear section balance beats a distant, reverb-washed mix.
Use Stem Splitter for brass, upload the stem here, or leave Auto on if the stack is already obvious.
Revoice stabs and split parts across your brass choir for a powerful section hit.
“Pop brass stack became MIDI I could explode into three tracks.”
“Hard mask kept strings out of the brass clip. Hits stayed readable.”
“Dropped the MIDI into Ableton, then I revoiced the stab. Faster than starting empty.”
Keep going — these tools pair well with what you just read.

Upload the take, keep brass section selected, and download a .mid for your DAW.