
Turn a song into harp MIDI you can edit. Upload MP3, WAV, M4A or FLAC, leave harp selected, check arpeggios on the piano roll against the recording, then drop the .mid into your DAW.
Play the source beside the piano roll. Rolled chords and melody notes are easier to trust when you hear the same beat before export.
This landing opens Audio to MIDI with harp already chosen. MIDI stays on the harp line instead of writing the whole orchestra.
Download the unquantized .mid for a harp library. Polish gliss runs and arpeggios for a finished cue.
Isolate harp with Stem Splitter first if strings and winds mask the part, then upload that stem here.
Fast glissandi land as editable note runs — polish them on your harp library in the DAW for a finished cue.
From the harp take you have to a .mid you can rewrite.
MP3, WAV, M4A or FLAC — harp solo, film cue, or a mix where the harp is clear. Or pick from My Music.
This page already chooses orchestral harp. Add another part only if it should share the MIDI.
Scrub rolled chords and melody notes against the recording before export.
Take the transcription MIDI into Ableton, Logic, or FL Studio.
When the roll looks right, take the .mid into your DAW. Printable harp staff is the sheet sibling's job.
Preferred DAW import — History surfaces the unquantized transcription MIDI first. Drop it into Ableton, Logic, FL Studio, or similar.
Load the .mid on a harp library, then polish arpeggios and gliss runs for the cue.

If the harp is buried under strings, isolate it first — then convert that stem.
Solo harp or a cue where the part sits up front beats a dense orchestral wash.
Use Stem Splitter for harp, upload the stem here, or leave Auto on if the line is already obvious.
Polish arpeggios and gliss runs on your harp library for a polished cue.
“Film cue harp became MIDI I could tempo-map without replaying.”
“Hard mask kept piano out of the harp clip. Arpeggios stayed readable.”
“Dropped the MIDI into Logic, then I redrew the gliss. Good starting grid.”
Keep going — these tools pair well with what you just read.

Upload the take, keep harp selected, and download a .mid for your DAW.