
Turn a song into string ensemble MIDI you can edit. Upload MP3, WAV, M4A or FLAC, leave string ensemble selected, check the section sketch on the piano roll, then drop the .mid into your DAW.
Play the source beside the piano roll. Chord pads and moving inner voices are easier to trust when you hear the same beat before export.
This landing opens Audio to MIDI with string ensemble already chosen. MIDI targets the section texture instead of a single solo line.
Download the unquantized .mid and break voicings across violin, viola, and cello tracks. This is a section sketch, not four finished parts.
Isolate strings with Stem Splitter first if vocals or brass dominate, then upload that stem here.
For a single violin, viola, cello, or double bass line, use that instrument's MIDI landing instead.
From the section take you have to a .mid sketch you can split.
MP3, WAV, M4A or FLAC — quartet, section pad, or a mix where strings are clear. Or pick from My Music.
This page already chooses string ensemble. Add another part only if it should share the MIDI.
Scrub pads and moving lines against the recording before export.
Take the transcription MIDI into Ableton, Logic, or FL Studio. Revoice across instruments there.
When the roll looks right, take the .mid into your DAW. Printable parts are the sheet sibling's job.
Preferred DAW import — History surfaces the unquantized transcription MIDI first. Drop it into Ableton, Logic, FL Studio, or similar.
Import the section .mid, then split voices and revoice the stack for your string template.

If the section is buried under vocals, isolate strings first — then convert that stem.
A clear section balance beats a distant hall mix with heavy reverb wash.
Use Stem Splitter for strings, upload the stem here, or leave Auto on if the section is already obvious.
Split and revoice the section MIDI across your string template for a full ensemble bed.
“The quartet take became MIDI I could explode into four tracks in Logic.”
“Hard mask kept brass out of the string clip. Section stayed readable.”
“Dropped the MIDI into Ableton, then I revoiced the pad. Faster than starting empty.”
Keep going — these tools pair well with what you just read.

Upload the take, keep string ensemble selected, and download a .mid for your DAW.