
Turn a song into drum MIDI for your kit or drum rack. Upload MP3, WAV, M4A or FLAC, leave drums selected, check the groove on the piano roll, then drop the .mid into your DAW.
Play the source beside the piano roll. Kick, snare, and hat patterns are easier to trust when you hear the same beat before export.
This landing opens Audio to MIDI with drums already chosen. MIDI stays on the kit instead of writing melodic instruments into the clip.
Download the unquantized .mid for a drum rack or sampler. Kick/snare/hats are usually cleaner than toms and cymbals — plan a remap pass.
We do not claim a General MIDI channel 10 kit map. Check hit mapping in your DAW and remap as needed.
Isolate drums with Stem Splitter first if the mix is dense, then upload that stem here. Timpani has its own pitched page.
From the kit take you have to drum MIDI you can remap.
MP3, WAV, M4A or FLAC — drum stem, break, or mix where the kit is clear. Or pick from My Music.
This page already chooses drums. Add another part only if it should share the MIDI.
Scrub kick/snare/hat patterns against the recording before export.
Take the transcription MIDI into Ableton, Logic, or FL Studio. Remap hits to your drum rack.
When the roll looks right, take the .mid into your drum rack. Drum notation on a staff is the sheet sibling's job.
Preferred DAW import — History surfaces the unquantized transcription MIDI first. Drop it into Ableton, Logic, FL Studio, or similar.
Drop the .mid into Ableton Drum Rack, FL FPC, or any sampler, then remap kicks, snares, and hats to your kit.

If the kit is buried under the band, isolate drums first — then convert that stem.
A drum stem or upfront break beats a muddy full mix.
Use Stem Splitter for drums, upload the stem here, or leave Auto on if the groove is already obvious.
Remap kicks, snares, and hats into Ableton Drum Rack, FL FPC, or your sampler kit.
“Dusty break became MIDI I could rebuild on my own kit without chopping audio.”
“Hard mask kept the bass out of the drum clip. Groove stayed readable.”
“Dropped the MIDI into Ableton Drum Rack, then I remapped hats. Fast skeleton.”
Keep going — these tools pair well with what you just read.

Upload the take, keep drums selected, and download a .mid for your drum rack.