
Turn a recording into mallet MIDI you can edit. Upload MP3, WAV, M4A or FLAC, leave mallets and bells selected, check the pitches on the piano roll, then drop the .mid into your DAW.
Play the source beside the piano roll. Short attacks and melody leaps are easier to trust when you hear the same beat before export.
This landing opens Audio to MIDI with chromatic percussion already chosen. MIDI stays on mallet pitches instead of inventing a full-band MIDI.
History surfaces the unquantized .mid first. Load it on vibes, xylophone, or glock, then tighten timing and grace notes for a sparkling mallet part.
Isolate the mallet stem with Stem Splitter if the line is buried, then upload that stem here.
This page is melody MIDI for mallets. Kit grooves belong on the drum MIDI landing; timpani has its own page.
From the mallet take you have to a .mid of pitches you can edit.
MP3, WAV, M4A or FLAC — vibes solo, xylophone cue, or a mix where mallets cut through. Or pick from My Music.
This page already chooses chromatic percussion. Add another part only if it should share the MIDI.
Scrub leaps and repeated notes against the recording before export.
Take the transcription MIDI into your host. Quantize and fix velocities there.
When the roll looks right, take the .mid into your DAW. Printable mallet score is the sheet sibling's job.
Preferred DAW import — unquantized transcription MIDI first from History.
Assign the .mid to vibes, xylophone, or glock, then tighten grace notes and velocities for a sparkling mallet part.

If the vibes are buried under brass, isolate them first — then convert that stem.
Solo vibes or a cue where mallets sit up front beats a dense orchestral wall.
Use Stem Splitter, upload the stem here, or leave Auto on if the line is already obvious.
Tighten grace notes and velocities in the piano roll so vibes, xylophone, or glock sparkle on the grid.
“Pulled the vibes melody into MIDI without hunting pitches for an hour.”
“Hard mask kept the kit out of the mallet clip. Huge time saver.”
“Dropped the mallet MIDI into Cubase, then tightened the grace notes. Fast path to a playable mallet part.”
Keep going — these tools pair well with what you just read.

Upload the take, keep mallets selected, and download a .mid for your DAW.