
Turn a song into synth lead MIDI you can edit. Upload MP3, WAV, M4A or FLAC, leave synth lead selected, check the mono line on the piano roll, then drop the .mid into your DAW.
Play the source beside the piano roll. Hook pitches are easier to trust when you hear the same beat before export.
This landing opens Audio to MIDI with synth lead already chosen. MIDI stays on the mono lead instead of writing pads or the whole band.
Download the unquantized .mid and drop it on any lead synth. Shape portamento and hook timing for the drop.
Isolate the lead stem with Stem Splitter first if the mix is dense, then upload that stem here.
Held pads and synth-string beds have their own MIDI landings.
From the lead take you have to a .mid hook you can rewrite.
MP3, WAV, M4A or FLAC — lead stem, hook, or mix where the synth lead cuts. Or pick from My Music.
This page already chooses synth lead. Add another part only if it should share the MIDI.
Scrub melody pitches against the recording before export.
Take the transcription MIDI into Ableton, Logic, or FL Studio.
When the roll looks right, take the .mid into your DAW.
Preferred DAW import — History surfaces the unquantized transcription MIDI first. Drop it into Ableton, Logic, FL Studio, or similar.
Load the .mid on any lead synth, then rewrite slides and hook timing for the drop.

If the lead is buried under chords, isolate it first — then convert that stem.
A solo lead stem beats a dense supersaw wall.
Use Stem Splitter, upload the stem here, or leave Auto on if the line is already obvious.
Rewrite slides and hook timing on any lead synth for a production-ready drop line.
“EDM hook became MIDI I could drop on a new lead without redrawing.”
“Hard mask kept the pad out of the lead clip. Hook stayed mono.”
“Dropped the MIDI into FL Studio, then shaped a few slides. Fast path to a lead hook.”
Keep going — these tools pair well with what you just read.

Upload the take, keep synth lead selected, and download a .mid for your DAW.