
Turn a song into synth strings MIDI you can edit. Upload MP3, WAV, M4A or FLAC, leave synth strings selected, check the string bed on the piano roll, then drop the .mid into your DAW.
Play the source beside the piano roll. Held beds are easier to trust when you hear the same beat before export.
This landing opens Audio to MIDI with synth strings already chosen. MIDI stays on the string-like bed instead of acoustic ensemble or a mono lead.
Download the unquantized .mid for a synth-string patch. Revoice the bed in your DAW for a finished mockup.
Isolate synth strings with Stem Splitter first if vocals dominate, then upload that stem here.
Live / sampled orchestral sections belong on the string ensemble MIDI page. Generic pads use synth pad.
From the string-bed take you have to a .mid you can revoice.
MP3, WAV, M4A or FLAC — synth-string stem or mix where the bed is clear. Or pick from My Music.
This page already chooses synth strings. Add another part only if it should share the MIDI.
Scrub chord changes against the recording before export.
Take the transcription MIDI into Ableton, Logic, or FL Studio.
When the roll looks right, take the .mid into your DAW.
Preferred DAW import — History surfaces the unquantized transcription MIDI first. Drop it into Ableton, Logic, FL Studio, or similar.
Import the .mid into a synth-string patch, then polish the bed for the mockup.

If the bed is buried under vocals, isolate it first — then convert that stem.
A solo synth-string stem beats a washed-out full mix.
Use Stem Splitter, upload the stem here, or leave Auto on if the bed is already obvious.
Polish the string-like bed in your host so the mockup feels finished.
“Synth-string bed became MIDI I could reharmonize under a new chorus.”
“Hard mask kept the lead out. Bed stayed a pad of notes.”
“Dropped the MIDI into Logic, then I cleaned the blocks. Fast mockup.”
Keep going — these tools pair well with what you just read.

Upload the take, keep synth strings selected, and download a .mid for your DAW.